Compliance checklist

3HD 5365 017330665 D5, BUSHING SLEEVE · N00104-26-Q-FD62. 178 requirement sentences found in the notice and 1 attachment: every "shall", "must" and "required", quoted as written and sorted into submission requirements (5) and performance / contract clauses (173). Nothing is generated.

Pro

The full checklist is a Pro feature

178 requirement sentences on this RFP. Pro shows every one, grouped by section, with a CSV export, for $39/mo. Below is a preview.

Submission requirements · 5

N00104-26-Q-FD62.PDF · Page 5 · 1

ECPs must be prepared in Contractor format, and must include the following information: a.

N00104-26-Q-FD62.PDF · Page 7 · 2

Welding procedures and qualification data must be submitted in a commercially available electronic format such as Adobe Acrobat PDF.
This request for NAVSUP-WSS Contracts must be submitted via the Electronic Contractor Data Submission (ECDS) application. 3.12.5 Any new procedure qualification performed under this Contract will require the vendor to provide a minimum 72 hour notification to DCMA with an offer to observe the welding of the test assemblies.

Performance / contract clauses · 173

N00104-26-Q-FD62.PDF · CONTACT INFORMATION · 1

When a DCMA office is shown on a Contract/Purchase Order, the Administrative Contracting Officer (ACO) is the primary point of contact and all inquiries shall initially be directed to that office for necessary action.

N00104-26-Q-FD62.PDF · ITEM NAME: BUSHING,SLEEVE · 2

APPLICABLE DOCUMENTS 2.1 Order of Precedence - In the event of a conflict between the text of this contract/purchase order and the references and/or drawings cited herein, the text of this contract/purchase order must take precedence.
Nothing in this contract/purchase order, however, must supersede applicable laws and regulations unless a specific exemption

Extracted from the notice text and attachments as published. The solicitation governs; read Sections L and M in full before you submit.